1 Quick Start
Turning on the Analyzer the First Time
Turning on the Analyzer the First Time
Initial power-on of the analyzer can be accomplished using the following methods:
During the initial power-on process, the instrument turns off and restarts several times.
This only happens during the initial installation process
Initializing the analyzer
Position the analyzer so you have easy access to the power cord and plug it in. See
"Instrument Location and Rack Mounting Requirements" on page 9 and "Power
requirements" under "Instrument Information" on page 14 for more details.
Steps Action Notes
1. Power on the analyzer
a. Press the power switch
(located in the lower left corner
of the analyzer’s front panel) to
turn the analyzer on.
The analyzer can require more than
5 minutes to power-on. The
Keysight Technologies screen
appears followed by a screen that
allows you to select Windows 7 or
the Recovery option.
2. Launch Microsoft Setup
The analyzer performs the following steps:
– Windows 7 Startup window
– Black screen
– Windows Please wait message window
– The following window appears giving you information about the End-
User License Agreement.
At this time, it is safe to turn off the instrument before initializing the
software.
After launching the setup, do not turn off the instrument or remove power
before the Setup Wizard completes and the system restarts. Turning off
the instrument may corrupt the system and the application may not
operate.
10 Getting Started and Troubleshooting Guide
To Next Page
Loading...
