KGuard Security Easy Link EL421 - Record Setup

ENGLISH
Chapter 4: Using the DVR
44
DVR User’s Manual
7 Aer all sengs are complete, click Apply.
« TIP »
• To copy the current sengs to other days, select the day, then click Copy.
• To copy the current sengs to other channels, select the channel, then click Copy.
8 When data saving is complete, click OK.
4.2.3 Record Setup
1 In preview mode, right-click on the mouse to display the Pop-up menu.
2 Select Main Menu > RECORD, then select the Record Setup tab. The Framerate sengs are displayed on a
table.
3 On Mode, select the type of record mode. Opons are: D1 or 960H.
Note:
If the record mode seng is set to 960H, it is recommended to use a 600 TVL or higher resoluon camera.
4 Select the channel and adjust the corresponding sengs such as Resoluon, FPS, and Quality.
Note:
If the frame rate set is over the system limitaon, a message is displayed on the screen.
5 Check the Audio box to enable audio.
6 Aer all sengs are complete, click Apply.
7 When data saving is complete, click OK.
« TIP »
To copy the record setup seng to other channels, select the channel(s) in Copy To, then click Copy.