Driving your vehicle
425
Brake system
僅 The EPB warning light may illuminate
if the EPB switch operates abnormally.
Shut the engine off and turn it on
again after a few minutes. The warn
-
ing light will go off and the EPB switch
will operate normally. However, if the
EPB warning light is still on, have the
system checked by a professional
workshop. Kia recommends to visit an
authorised Kia dealer/service partner.
僅 If the parking brake warning light
does not illuminate or blinks even
though the EPB switch was pulled up,
the EPB is not applied. If the parking
brake warning light blinks when the
EPB warning light is on, press the
switch, then pull it up. Once more
press it back to its original position
and pull it back up. If the EPB warning
does not go off, have the system
checked by a professional workshop.
Kia recommends to visit an authorised
Kia dealer/service partner.
AUTO HOLD (if equipped)
The Auto Hold is designed to maintain
the vehicle in a standstill even though
the brake pedal is not pressed after the
driver brings the vehicle to a complete
stop by pressing the brake pedal.
Applying Auto Hold function
1. Press the brake pedal and start the
vehicle.
2. Press the Auto Hold button. The white
AUTO HOLD indicator will come on
indicating the system is in standby.
Before the Auto Hold will engage, the
driver's door and engine bonnet must
be closed and the tailgate must be
closed.
When coming to a complete stop by
pressing the brake pedal, the AUTO
HOLD indicator changes from white to
green indicating the AUTO HOLD is
engaged. The vehicle will remain at a
standstill even if you release the brake
pedal.
If EPB is applied, Auto Hold will be
released.
If you press the accelerator pedal with
the shift lever in D (Drive) or Manual
mode, the Auto Hold will be released
automatically and the vehicle will start to
move. The indicator changes from green
To Next Page
Loading...
