Driving your vehicle
1085
Cruise Control (CC)
Cruise Control (CC) (if
equipped)
1. Cruise indicator
2. Set speed
Cruise Control will allow you to drive at
speeds above 30 km/h (20 mph) without
depressing the accelerator pedal.
Cruise Control operation
Setting set speed
1. Accelerate to the desired speed,
which must be more than 30 km/h
(20 mph).
2. Press the Driving Assist button at the
desired speed. The set speed and
Cruise ( ) indicator will illu
-
minate on the cluster.
3. Release the accelerator pedal.
Vehicle speed will maintain the set
speed even when the accelerator
pedal is not depressed.
On a steep slope, the vehicle may
slightly slow down or speed up whilst
driving uphill or downhill.
Increasing set speed
僅 Push the + switch up and release it
immediately. The set speed will
increase by 1 km/h (1 mph) each time
the switch is operated in this manner.
僅 Push the + switch up and hold it whilst
monitoring the set speed on the clus
-
ter. The set speed will increase to the
nearest multiple of ten (multiple of
five in mph) at first, and then increase
by 10 km/h (5 mph) each time the
switch is operated in this manner.
Release the switch when the desired
speed is shown and the vehicle will
accelerate to that speed.
To Next Page
Loading...
Need help?
General
