3-4 Names and Functions of Parts PLZ-U
RANGE
Switches the CC/CV range in the respective operation mode. Each time you press
the RANGE key, the range switches in the order L, M, and H. You can check the
current range with the range indicator (CC/CR RANGE) of the frame or channel.
V RANGE
Each time you press this key while holding down the SHIFT key (SHIFT +
RANGE) when in CV, CC+CV, or CR+CV mode, the CV range switches in the
order L and H. You can check the current range with the CV RANGE LED of the
frame or load unit.
[6] SET key
Press this key to set the current, resistance, or voltage of CC, CR, or CV mode,
respectively, on the selected channel.
In CC+CV or CR+CV mode, press the SET key to switch between current and volt-
age and set the values.
[7] Rotary knob
The rotary knob is used to set various types of values on the PLZ-U.
[8] SHIFT key
If you press a key while holding down the SHIFT key, the function indicated below
the key in blue is enabled. If you press a key without holding down the SHIFT key,
the function indicated above the key is enabled.
[9] Range indicator
The LED indicating the range of CC, CR, or CV mode of the selected channel illu-
minates.
[10] Channel display
Press the ENTRY key on a load unit to display the channel number on the selected
load unit.
[11] Setup display
Displays settings, setup memory number, configuration value, etc.
[12] Unit indicator
The LED indicating the unit of the value illuminates.
[13] SW, SEQ, and STORE indicators
[13-1] SW indicator
The selected channel illuminates in switching mode.
[13-2] SEQ indicator
The selected channel illuminates in sequence mode.
[13-3] STORE indicator
Illuminates when waiting for the setup memory to be stored. The indicator turns off
when you press the ENTER key and the store operation completes.
To Next Page
Loading...
Need help?
General
