PLZ-U Basic Operation 4-7
3. Sets the range.
In CC or CR mode, press the RANGE key to set the CC/CR range.
Each time you press the RANGE key, the range LED illuminates in the
order L (Low), M (Mid), and H (High), and the range is switched.
In CV mode, press the V RANGE (SHIFT +RANGE) key to set the CV range.
Each time you press the V.RANGE (SHIFT + RANGE) key, the range
LED (V RANGE) illuminates in the order H (High) and L (Low), and the
CV range is switched.]
• The range value varies depending on the model. For details on the range values of
the PLZ-U, see chapter 8, “Specifications”
4.
Change the setting.
Press the SET key and turn the rotary knob.
If you added +CV mode, CC SET and CV SET toggles each time you press the
SET key. Check the unit indicator.
In CR mode, the resistance (Ω) is shown at the upper section and the
conductance (S) is shown at the lower section of the setting display. The
conductance unit is not indicated on the display. However, the conduc-
tance unit is S when the resistance unit is mΩ and mS when the resis-
tance is Ω or kΩ.
5.
Turn on the load.
If you press the LOAD key of the selected channel, the load is turned on only
on the channel.
If you press the LOAD key of the frame, the load is turned on on all channels
simultaneously. For channels on which you do not wish to turn on/off the load
simultaneously, press the INDEP key to enable independent mode.
The LOAD LED illuminates, and the current flows. The channel display
shows the measured value.
6.
Change the setting.
Turn the rotary knob while the load is turned on to change the setting.
Press the A, B, or C key while the load is turned on to recall the saved setting.
(For details, see section 5.2, “ABC Preset Memories.”)
7.
Turn off the load.
If you press the LOAD key of the channel, the load is turned off only on the
channel.
If you press the LOAD key of the frame, the load is turned off on all channels
simultaneously.
The LOAD LED turns off, and the current is cut off.
NOTE
To Next Page
Loading...
Need help?
General
