Kintech Engineering ORBIT 360 - Status; Logger Status

KINTECH ENGINEERING
ORBIT 360 | USER GUIDE
77
1
st
line  channel ID, e.g. “Analog 4”.
2
nd
line  Sensor model ID, e.g. “1A GEOVANE TILT X”.
3
rd
line  Instantaneous value, e.g. “Inst: 0.9º”.
4
th
line  Average value, e.g.”Avg: 0.4º”. Note that, just after turning on the
logger, there will be no average value available until a 10-min interval has been
exceeded.
7.5.4 ANALOG 9-23
In this window you can access both real time and the last averaged value of every analog
channel ranging from 1 to 8. The values will be expressed in the default units for that
particular magnitude.
1
st
line  channel ID, e.g. “Analog 12”.
2
nd
line  Sensor model ID, e.g. “61 GEOVANE TILT X”.
3
rd
line  Instantaneous value, e.g. “Inst: -1.4º”.
4
th
line  Average value, e.g.”Avg: 1.4º”. Note that, just after turning on the
logger, there will be no average value available until a 10-min interval has been
exceeded.
7.5.5 STATUS
This screen provides information regarding the status of the data logger, as well as other
system parameters such as firmware and hardware version, the serial number, or the of
the GSM/GPRS coverage and current communication status.
7.5.5.1 Logger status
Go to [STATUS  Logger Status] for general information about the status of the logger.