EasyManuals Logo

KMC Controls SimplyVAV BAC-8001 User Manual

KMC Controls SimplyVAV BAC-8001
75 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
Advanced options
The advanced options set up passwords and special features in the controller.
l Establish or change Password 1 and Password 2
l Set timers for standby and override (optional)
l Enable automatic occupancy (optional)
l Enable discharge air temperature control (optional)
l Calibrate the sensor
Setting the advance options requires entering Password 2 which is described in the topic
Getting started with configuration on page 21.
Tip: Once the following procedure is started, all steps must be completed in order.
Procedure Steps Sensor display
1 Starting display
1. Start at the temperature display.
2.
Press the and buttons together.
l If Password 2 is not required, the display
changes to CNFG.
l If required, enter Password 2. The display
changes to CNFG when Password 2 is correct.
72
12S1
PSW2
OOOO
2 Select the advanced display.
1.
From the CNFG display, press the
Set
Point
button to show
the STPT display.
2.
Press the or buttons to change the display to
ADVC.
3.
Press the
Set
Point
button to select ADVC.
CNFG
STPT
ADVC
3 Change Password 1.
Note: Entering four zeros (0000) removes the password.
1.
Press the or buttons to change the first digit.
2.
Press the
Set
Point
button to select the next digit. Repeat
for all four digits.
PSW1
OOOO
Table 4–1 Procedure to set the advanced options
SimplyVAV Section 4: Configuring the controllers
Revision H 33

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the KMC Controls SimplyVAV BAC-8001 and is the answer not in the manual?

KMC Controls SimplyVAV BAC-8001 Specifications

General IconGeneral
BrandKMC Controls
ModelSimplyVAV BAC-8001
CategoryController
LanguageEnglish

Related product manuals