Kodak Ektalite 500 - Installation for the MOTOR; Removal for the WORM PULLEY and MECHANISM BELT

SERVICE MANUAL Removals and Installations
23JUL01
SM5766-1
Page
13 of 96
Installation for the MOTOR
Important
When installing the FAN and MECHANISM BELTS, install the MECHANISM BELT on the
small MOTOR PULLEY, and the FAN BELT on the large MOTOR PULLEY.
1 Do the removal for the MOTOR in reverse order.
Removal for the WORM PULLEY and MECHANISM BELT
Warning
Dangerous Voltage
1 Disconnect the main power.
2 Do the removal for the LOWER HOUSING ASSEMBLY.
3 Do the removal for the MOTOR except do not disconnect the wires from the MOTOR.
4 Remove the Torx SCREW from the WORM PULLEY ASSEMBLY.
A091_4015BA
A091_4015BCA
MECHANISM BELT
FAN BELT