Kodak Ektalite 500 - Removal for the CYCLE SOLENOID ASSEMBLY

SERVICE MANUAL Removals and Installations
23JUL01
SM5766-1
Page
19 of 96
Removal for the CYCLE SOLENOID ASSEMBLY
Warning
Dangerous Voltage
1 Disconnect the main power.
2 Do the removals for the LOWER
HOUSING ASSEMBLY and the
MOTOR.
3 Disconnect the 3 CONNECTORS on
the MAIN BOARD. It is not necessary to
disconnect the CONNECTORS next to
the LOWER LIGHT BAFFLE
ASSEMBLY.
4 Lift the MAIN BOARD up.
5 Cut and remove the necessary WIRE
TIES.
6 Disconnect the 2 violet wires from the
CYCLE SOLENOID on the SMALL
BOARD.
7 Pull the SMALL BOARD up.
8 Remove the To rx SCREW from the
WORM PULLEY SHAFT.
9 Move the TAB on the WORM PULLEY
ASSEMBLY out of the MECHANISM
ASSEMBLY.
10 Lift and remove the WORM PULLEY
ASSEMBLY.
A091_4014GA
PLUNGER
SOLENOID
CYCLE
SOLENOID
CYCLE
A091_4014GCA
SCREW (2)