Kodak Ektalite 500 - Installation for the LENS MOUNT ASSEMBLY - 500 and 1000 PROJECTORS Only; Removal for the AUTO-FOCUS SWITCH ASSEMBLY - Models 1500 and 2000 PROJECTORS Only

SERVICE MANUAL Removals and Installations
23JUL01
SM5766-1
Page
34 of 96
Installation for the LENS MOUNT ASSEMBLY - 500 and
1000 PROJECTORS Only
1 Do the removal for the LENS MOUNT ASSEMBLY in reverse order.
Removal for the AUTO-FOCUS SWITCH ASSEMBLY - Models 1500 and
2000 PROJECTORS Only
Warning
Dangerous Voltage
1 Disconnect the main power.
Important
There is no AUTO-FOCUS SWITCH
ASSEMBLY on the Models 500 and 1000.
2 Do the removal for the LOWER
HOUSING ASSEMBLY.
3 Disconnect the 3 CONNECTORS on
the MAIN BOARD. It is not necessary to
disconnect the CONNECTOR next to
the LOWER LIGHT BAFFLE
ASSEMBLY.
4 Lift the MAIN BOARD up.
5 Remove the FOCUS KNOB.
6 Remove the short, gray wire from the
AUTO-FOCUS DEFEAT SWITCH.
A091_4028GA
wires
and black
grey, red,
A091_4028GCA
SWITCH LEVER
AUTO FOCUS SWITCH ASSEMBLY
TAB
LOCKING
AUTO FOCUS
MOTOR BRACKET
AUTO FOCUS