SERVICE MANUAL Adjustments
23JUL01
SM5766-1
Page
47 of 96
4 Disconnect the MAIN BOARD from the 4 POSTS to allow access to the FOCUS LIGHT
PATH.
Important
It is necessary to make a FAN COVER TOOL. See the Tools section.
5 Install the FAN COVER TOOL over the FAN area and the LAMP MODULE.
6 Energize the projector.
7 Set the projector to the LOW LAMP position.
8 Install the AUTO-FOCUS TARGET SLIDE TL-3002 until it is fully seated in the GATE
MECHANISM.
To Next Page
Loading...
