25 MODE
1 ADJUSTMENT
*17 Copy count limit
*18 Page memory allocation when powered
*19 Page memory allocation when starts
When memory overflow occurs in a mode where
page memory is used, this bit allocates page
memory at the start of job to print out copied
paper, the data of which was already read in the
memory.
Page memory quantity differs as in the following
table, according to the number of gradation.
When “Allocated” is selected by DIP switch 10-0
or 10-1 with power supply ON, this setting has
priority.
*20 Transfer/separation out put for high-quality
paper
These bits are used when “High-quality” is
selected for “Paper type/special size setting” in
the key operator mode.
When “No specification” is selected, output data
by paper size (metric or inch system) (metric:
64g/m
2
standard paper, Inch: 20 lb standard
paper) is used.
*21 Size detection 4
*22 F4 size detection
*23 Maximum number of sheets that can be stapled
*24 FNS alarm stop SW
Mode 9-7 9-6 9-5 9-4
No limit 0 0 0 0
1 copy 0 0 0 1
3 copies 0 0 1 0
5 copies 0 0 1 1
9 copies 0 1 0 0
10 copies 0 1 0 1
20 copies 0 1 1 0
30 copies 0 1 1 1
50 copies 1 0 0 0
99 copies 1 0 0 1
250 copies 1 0 1 0
No limit 1 0 1 1
No limit 1 1 0 0
No limit 1 1 0 1
No limit 1 1 1 0
No limit 1 1 1 1
Mode 10-1 10-0
No allocation
00
32 MB (default for DP65)
01
64 MB
10
1 bit ED
18 MB (11x17 x 2)
2 bit ED
36 MB (11x17 x 2)
Mode
10-2
No allocation
0
Allocated
1
Mode 10-7 10-6 10-5 10-4
No specification
0000
64 g/m
2
(16 lb) paper
for printing press
0001
80g/m
2
(20 lb) paper
for printing press
0010
Copied backing
papers (7255/7272)
0011
Destination Mode 13-4 13-3
Metric series
A5R 0 0
B6R 0 1
Inch series
5.5 x 8.5R 1 0
Mode 13-6 13-5
8 x 13
00
8.25 x 13
01
8.125 x 13.25
10
8.5 x 13
11
Mode 15-2 15-1
50 sheets
00
45 sheets
01
40 sheets
10
35 sheets
11
Mode 15-4 15-3
Stop immediately after detection
00
Stop at end of copy after detection
01
No alarm stop
10
No alarm stop
11
4
1-18
MODEL MANUAL REVISED EDITION DATE PAGE METHOD
SERVICE MANUAL Dec. 2003
7155/7165/7255/7272
1-18 ADDITION
4