Konica Minolta CL-70F - Page 47

34
4. Setting the Measuring Conditions
5.
Touch the [Exposure Time] indication in the Measurement screen.
Set the exposure time to Auto, 0.1 sec, or 1.0 sec during ambient light
measurement. (
¨
P24)
6.
Press the Measuring Button 5 to measure.
The Light Selection Ring
2
should be set to L  )
when taing ambient light measurements.
When measuring ash units, select Range L  )
or Range   ) depending on the brightness of
the ash. 
¨
77,
¨
7)
Measurements can now be made.
NOTE
Measurement and display will tae longer in light levels below 0l. The LC
illumination will normally switch off during measurement to avoid inuence to
measurement.
7.
Memorize the measurement results.
Measurement results can be memoried.
To record measurements, press Memory utton
7
. 
¨
)
Light Selection Ring
2
Measuring Button
5