Konica Minolta CL-70F - When [Over], [Under] or; Display of [Over], [Under] or

77
5. Measuring Light Sources [Measurement Screen]
5-6
When [Over] , [Under] or [---] is Displayed
When ver or nder is displayed, the light source is out of measuring range.
When --- is displayed, the color temperature is outside the calculation range.
5-6-1 Display of [Over] , [Under] or [---]
When [Over] is displayed:
If the amount of light being measured is brighter than the
maimum measuring range, ver is displayed.
When measuring ambient light, decrease the brightness of the
illumination.
When measuring high power ash light, turn the Light
Selection Ring
2
, and change the range from L ( ) to
H ( ), or lower the ash output power.
When [Under] is displayed:
If the amount of light being measured is lower than the
minimum measuring range, nder is displayed.
When measuring ambient light, increase the brightness of the
illumination.
When measuring ash light, turn the Light Selection Ring
2
,
and change the range from H ( ) to L ( ), or
raise the ash output power.
When the color temperature is outside the calculation
range, [---] is displayed.
NOTE
Measurement and display will tae longer in light levels below 0l. The LC illumination
will normally switch off during measurement to avoid inuence to measurement.
Light Selection Ring
2
Measuring utton
5