Konica Minolta CL-70F - Page 91

78
5. Measuring Light Sources [Measurement Screen]
5-6-2 Changing the Light Range
Change and use the light range depending on the brightness of the ash.
Light Selection Ring
(Status Bar Display)
Content
Dark Calibration
Position
Select for dark calibration only. Measurement cannot be
made in this position.
Range L
Select for LL ambient light measurement, and low
power ash units lower than 0ls)
Range H
Select for powerful ash units brighter than 0ls)
only.
Turn the Light Selection Ring
2
and select the desired range.
The set range will be displayed on the LC screens status bar.
Status Bar
RANGE L
RANGE H
Light Selection Ring
2
RANGE H
RANGE L