Konica Minolta CL-70F - Monitor Function (in Ambient Light Mode Only)

73
5. Measuring Light Sources [Measurement Screen]
5-5 Monitor Function (in Ambient Light Mode only)
The Monitor function displays a difference between the
preset reference value and the measured value.
When you touch the Delta icon ( ) in the Display
mode, it changes to  ) (This function is not
activated in Spectrum Comp., CI Comp. and
CI7 Comp. mode).
When Monitor Function is selected, the difference
between the preset and current value is shown while you
are pressing Measuring utton
5
.
When the Measuring utton
5
is released, the
measurements will stop and the difference with the preset
reference value at the time of release will be displayed.
Operation
1.
Touch the [Preset Selection (2°) (Preset Selection (10°))] button in
the Tool Box.
The Preset Selection screen will be displayed.
NOTICE
A Preset value must be created and saved in the Preset Editing function
under the "Setting Mode" icon before it can be used.
Preset Selection buttons will be grayed out until settings are created.
Measuring utton
5
Tool Box Screen Preset Selection (2°) Screen