Konica Minolta CL-70F - Page 85

72
5. Measuring Light Sources [Measurement Screen]
6.
Press the Measuring Button 5.
Measurement will be taken with ash, and the light source values will be
displayed.
ecause it affects measurement while measuring, the LC baclight will dim. This is normal.
Measurement in Cord (PC) Flash Mode is complete.
CAUTION
●
Depending on the ash euipment used, the ash may be triggered when the
sync cord is connected to the Sync Terminal
b
or when operating the Power
Button
3
. Because there is the possibility of burns or negative effects on
vision, please handle with care.
●
D o not trigger ash while skin or other objects are in contact with the ash
tube. Do not touch the ash tube after continuous ashes. (It may cause burns.)
●
Do not trigger ash while near the eyes of people or animals. (It may
temporarily affect vision.)
●
The ash may be triggered suddenly. Because there is the possibility of
burns or negative effects on vision, please handle with care.
NOTICE
●
If the triggering voltage of the ash used is extremely low, the ash may not
trigger. In this care, use "5-3 Measurement in Cordless Flash Mode". (
¨
P65)
●
In the Cordless Flash mode, the measured color temperature may change
depending on the shutter speed set for ash measurement and the amount of
ambient light present when the measurement is made.
NOTE
ver or nder will be displayed if the light source illumination is too bright or not bright enough,
or if the color temperature is out of the measurement range, when the Measuring utton is pressed.
When the color temperature is outside the calculation range, --- is displayed.
In this case, adust the brightness or color temperature of light source, or switch the light
range. (
¨
P78)