Konica Minolta CL-70F - Page 49

36
4. Setting the Measuring Conditions
5.
Press the Measuring Button 5 to measure.
The Light Selection Ring
2
should be set to L  )
when taing ambient light measurements.
When measuring ash units, select Range L  )
or Range   ) depending on the brightness of
the ash. 
¨
77,
¨
7)
Measurements can now be made.
NOTE
Measurement and display will tae longer in light levels below 0l. The LC
illumination will normally switch off during measurement to avoid inuence to
measurement.
6.
Touch the [Magnifying Glass (+)] icon on the screen.
The spectrum distribution graph will be enlarged.
The enlarged graph is displayed on the whole screen landscape).
To return to the Spectrum screen, touch the Magnifying lass -) icon on the enlarged
spectrum distribution graph.
NOTICE
When the enlarged graph is displayed, measurement cannot be
performed.
Light Selection Ring
2
Measuring Button
5
Measurement
results are
displayed.
Spectrum Distribution Graph
Enlarged Display
Spectrum Screen