Konica Minolta CL-70F - Page 62


4. Setting the Measuring Conditions
4.
Press the Measuring Button 5 to measure.
The Light Selection Ring
2
should be set to L  )
when taing ambient light measurements.
When measuring ash units, select Range L  )
or Range   ) depending on the brightness of
the ash. 
¨
77,
¨
7)
Measurements can now be made.
NOTE
Measurement and display will tae longer in light levels below 0l. The LC
illumination will normally switch off during measurement to avoid inuence to
measurement.
5.
The current measurement value is indicated by a black "x".
6.
Touch the [Memory Selection] icon.
The [CIE1931 (CIE1964) Comp.] screen will be displayed.
Light Selection Ring
2
Measuring Button
5
CIE1931 (CIE1964) Comp.
Screen
CIE1931 (CIE1964) Comp. Memory
Screen
Memory
Selection
Area
Measured value
Memory
Selection] Icon
Current
Measurement