25
3.
Press the YES button to show a conrmation message.
4.
Press the YES button again to randomize.
Detailed editing
You can make detailed edits as follows.
1.
Press the desired PAGE SELECT button between the MODE and EFFECT buttons to display the
corresponding page. To display one of the secondary pages as shown below the buttons, hold the
SHIFT button down and select the desired page.
2.
Sometimes the le side of the screen will indicate that multiple subpages are available. You can
use the PAGE < and > buttons to cycle through them.
3.
You can edit the parameters for each Operator on the MODE, PITCH and LEVEL pages. Use the
OP SELECT + and − buttons to select the Operator to edit.
t the Operator
to edit using the OP
SELEC
T + and −
4.
Use the DATA ENTRY A–F knobs to change the parameters.
Each page’s editable parameters are shown below:
MODE: Change the Operator mode and output waveforms for OP 1–6.
PITCH: Change the pitch of OP 1–6, as well as the pitch modulation from the LFO/EG.
LEVEL/EG: Set the output levels, EG and key tracking for OP 1–6.
MOD: Congure LFO 1–3 and EG 1–3.
FILTER: Set the overall lter used for OP 1–6.
EFFECT: Used for selecting eect types or making detailed edits to the eects.
ARP: Congure the arpeggiator.