41
OPERATORS: MODE
MODE: OP1...6 (Operator Mode)
MODE
Selects the Operator mode. (See “Operator modes”, p.7)
WAVE
is selects the waveform of the oscillator. (See “Waveform List”, p.77)
When “MODE” is set to FM (Frequency Modulation)
e pitch of an oscillator can be changed using the input signal from the modulator.
FB (Feedback)
Adjusts the amount of self-feedback from the Operator. When “WAVE” is set to “SIN”, the sound will
become brighter the closer that the feedback value gets to 75%, sounding more like a sawtooth wave.
When the feedback value exceeds 75%, the sound will become more like complex noise as the value
gets larger.
WIDTH (Wave Width)
is sets the width of the waveform that was congured using the “WAVE” parameter. You can
control the value using V.Patch to get distinctive sounds like those used in dance music.
To Next Page
Loading...
