Korg opsix - Seq

74
See the graphic below.
0 100
80
Initial knob position
Cu
rrent value:
90
40
0 100
50
Knob moved to minimum
7525
Range is scaled around initial position Ra
nge is reset to even distribution
Jump:
When a knob is moved, the parameter value instantly changes to match the position of
the knob.
SST Hold Time
is controls the duration of Smooth Sound Transitions. It sets how long reverbs, delays, and note
releases continue to ring out aer a new sound has been selected. e timer starts aer all notes from
the previous sound are no longer being held down, and the sustain pedal is released.
SEQ
Trigger Quantize
is prevents the sequence from getting out of rhythm by lining up the timing of the sequencer steps
(quantizing) when using the step jump or key trigger function. e operation will be immediately
reected when this is OFF, but setting this to 1, 2 or 4 steps will quantize the timing of the step
interval you set.
Record Quantize
is automatically corrects the timing of notes that are played during real-time recording.
Off:
e note-on and note-o timing will be reected into the START and GATE parameters
as-is.
Start:
e note-on timing will always be at the beginning of each step. e note-o timing will
be reected in the GATE parameter.
All:
e note-on timing will always be at the beginning of each step. e GATE parameter will
be set to 75% or “TIE”, according to the note-o timing.
Metronome
Sets whether the metronome will sound during real-time recording.