Korg opsix - Misc; PROG PITCH (Program Pitch)

66
MISC
PROG PITCH (Program Pitch)
TRANS (Transpose)
Adjusts the overall pitch in semitone steps over a range of ±1 octave for the entire program.
OCT (Octave)
is sets the basic pitch, in octaves. e default is 0.
BEND (Pitch Bend Up)
is sets the maximum amount of pitch bend, in semitones, when you move the wheel above the
center point. For normal pitch bend, set this to a positive value.
BEND (Pitch Bend Down)
is sets the maximum amount of pitch bend, in semitones, when you move wheel below the center
point. For normal pitch bend, set this to a negative value.
LFO1 (LFO1 Int)
is controls the initial eect of the LFO1 on the pitch, in semitones.
CTRL (LFO1 Ctrl Src)
Selects the modulation source that controls the LFO1 Int. e source value selected here is multiplied
with LFO1 Int to determine the depth of the modulation eect. (See “Control Source List”, p.78)