Korg opsix User Manual

54
FLTR MOD (Filter Modulation)
LOW (KeyTrk Low Slope)
Sets the depth of key tracking for notes that are lower than the Center Key. When this is set to a
positive value, the cuto frequency correspondingly increases for lower notes. When this is set to a
negative value, the cuto frequency correspondingly decreases for lower notes. A setting of “–1.00”
will make the cuto frequency change with the same slope as the key pressed on the keyboard.
HIGH (KeyTrk High Slope)
Sets the depth of key tracking for notes that are higher than the Center Key. When this is set to a
positive value, the cuto frequency correspondingly increases for higher notes. When this is set to a
negative value, the cuto frequency correspondingly decreases for higher notes. A setting of “+1.00”
will make the cuto frequency change with the same slope as the key pressed on the keyboard.
CENTER (KeyTrk Center Key)
is sets the note used as a reference for keyboard tracking. e cuto frequency will change
according to the distance between the inputted note and the reference note. When you play the same
note as the reference note, the cuto frequency will be the same as the setting on the Filter page.
LFO2 (LFO2 Int)
is sets the amount that the LFO2 modulates the cuto parameter.
CTRL (LFO2 Ctrl Src)
Selects the modulation source that controls the LFO2 Int. e source selected here is multiplied with
LFO2 Int to determine the amount of cuto modulation. (See “Control Source List”, p.78)

Korg opsix Specifications

General

Equalizer	Yes
Product type	Digital synthesizer
Product color	Black
Sound effects	Chorus, Flanger/Digital Signal Processing (DSP), Phaser, Reverberation
Sound effects quantity	500
Keyboard number of keys	37
Maximum polyphony (notes)	32
Headphone outputs	1
DC input voltage	12 V
Power source type	AC

Weight and Dimensions

Depth	338 mm
Width	565 mm
Height	90 mm
Weight	2900 g