174
2 Select “Finalize Audio CD” to access the dialog box.
3 Press the OK button to execute the Finalize command, or
press the Cancel button to cancel without executing.
0–4D: Erase CD-RW
This command erases the audio tracks from CD-R/RW
media.
To avoid errors, do not subject the TRITON STUDIO to
vibration or physical shock while data is being written
to the CDRW-1 option (if installed), or while formatting
is taking place.
1 Use “Drive select” to select the drive, and make sure that
it contains data.
2 Select “Erase CD-RW” to access the dialog box.
3 Select the mode by which the audio tracks will be erased.
Quick Erase: Normally you will select this.
Full Erase: The data will be erased completely. Substan-
tial time will be required for the erasure.
When you execute Quick Erase, the files and data will
appear to be gone, but the data itself will remain on the
disc until it is overwritten. If you want to erase data
that should not be seen by someone else, execute Full
Erase to erase the data completely.
4 Press the OK button to execute the Erase operation, or
press the Cancel button to cancel without executing.
If the CDRW-1 option is installed, or if a CD-R/RW drive is
connected as an external SCSI device, you can play back
audio CD’s in Disk mode.
If you are using a SCSI-connected CD-ROM/R/RW drive,
connect the audio outputs of the drive to the AUDIO INPUT
1 and 2 of the TRITON STUDIO.
It is convenient to use this method to verify a CD that you
created in the Make Audio CD page.
The audio CD will play back according to the Analog setting
for “Input (COMBI, PROG, SEQ, S.PLAY, DISK).”
It is not possible to play back an audio CD that has not
been finalized.
The audio CD can be controlled by the SEQUENCER keys.
If the CDRW-1 option is installed, playing the TRITON
STUDIO’s keyboard or operating the controllers during
CD playback may produce physical shock that causes
the data to skip or read errors to occur, preventing play-
back from occurring normally. Please use caution.
0–5a: Location, Drive, Track, Index, Volume
Location (00:00.0...)
Displays the current location of the audio track that is play-
ing. When stopped, this specifies the location at which play-
back will begin.
When “Track” or “Index” are re-selected, this will be 00:00.0.
Drive
Specifies the drive of the audio CD that will be played.
Only CD-ROM/R/RW drives can be selected.
Track [01...]
Selects the audio CD track that will be played.
Index [01...]
Specifies the index of the audio CD that will be played. This
is valid only if you have selected a track that has index data.
In the case of some CD-R/RW drives, index informa-
tion cannot be obtained.
Volume [0...127]
Specifies the volume of the audio output from the CD-R/
RW drive.
0–5: Play Audio CD
SEQUENCER[START/STOP] key : Play/Stop
[FF>>] key : Fast-forward
[<<REW] key : Rewind
[PAUSE] key : Pause
[LOCATE] key : Return to the beginning
of the track
0–5
0–5a
0–5b
To Next Page
Loading...
Need help?
General
