BA 348-01 * 2.0 * 34801b340.fm 3-75
Operation 3
Removing a standard bucket from the quickhitch
Position the attachment so that it will stand safely and not tip over once it is
unlocked from the quickhitch!
☞Drive the wheel loader with the attachment to the drop-off position
☞Lower the loader unit. To do this: push control lever 11 to position C,
➥until the attachment is about 5 – 10 cm above the ground (horizontally)
☞Unlock the 3rd control circuit
➥–seeOperating and securing the 3rd control circuit (standard) on page 3-65
➥–seeElectrical operation and locking of 3rd control circuit (option) on page 3-67
☞Unlock the attachment. To do this: push control lever 12 forward to position O
➥The lock pin moves out of the mounting bores of the attachment
☞Lower the loader unit completely. To do this: push control lever 11 to position C and at
the same time, tilt the quickhitch forward. To do this: push control lever 11 to position B
☞Reverse the wheel loader away from the attachment
Fig. 99 : Lowering and tilting out the attachment
12
O
Z
A
B
C
D
11
To Next Page
Loading...
