BA 348-01 * 2.0 * 34801b330.fm 3-31
Operation 3
Disabling the drive interlock
☞Enter the personal code or main code (6 digits).
☞Press the (*) key.
➥Confirmation: 2 long acoustic signals and long LED flashing
➥LED OFF = drive interlock is disabled
➥Diesel engine can be started
If the diesel engine cannot be started: the wrong code has been entered
➥Confirmation: 4 short acoustic signals, flashing LED = wrong code
➥Re-enter the code
☞Turn the ignition key and start the engine before the LED flashes again (30 seconds)
The keypad is blocked for 5 minutes and no codes can be entered if the wrong
code is entered four times consecutively.
☞Enter the code after 5 minutes
• The keypad does not illuminate as long as it is blocked. It illuminates
briefly every 4 seconds and an acoustic signal sounds
☞Press the (*) key after every code
☞The LED illuminates briefly when turning the ignition key to position
“Engine start”
To Next Page
