BA 348-01 * 2.0 * 34801b340.fm 3-105
Operation 3
Picking up loads with the pallet forks
If the machine is equipped with the “Hose burst valve” option, ensure that the
load stabilizer (option) is switched off!
If the load stabilizer is switched on, the hose burst valve is disabled and offers
no protection in the event of line damage. In other words, the loader unit can
be lowered and an attachment tilted out
☞Pick up loads as follows:
• Move the machine up to the load so that the pallet forks or the fork arms are at a right
angle to the load
➥ The fork arms must be the furthest possible apart, and at an equal distance from
the left and right side of the load.
• Drive the machine forward and move the fork arms as far as possible underneath the
pallet until the material touches the fork frame
• Raise the load carefully and tilt it in slightly
In order to avoid damage to the machine, no not exceed the machine’s output limit!
☞Observe the load diagram –seeLoad diagram for pallet forks on page 3-104!
Ansicht_021.iso
Fig. 142 : Position of fork arms with regard to load
Ansicht_022.iso
Fig. 143 : Picking up a load
Ansicht_023.iso
Fig. 144 : Raising the load
To Next Page
Loading...
