Kramer 350

BA 348-01 * 2.0 * Sicherheit_Radlader.fm 2-13
Safety instructions 2
Hydraulic system
• Work on the hydraulic equipment of the machine must be performed only by persons
having special knowledge and experience in hydraulic systems!
• Check all lines, hoses and threaded fittings regularly for leaks and obvious damage!
Repair any damage and leaks immediately! Splashed oil can cause injury and fire!
• In accordance with the Operator’s Manual/instructions for the respective assembly,
release the pressure in all system sections and pressure lines (hydraulic system) to
be opened before performing any implementing/repair work!
• Hydraulic and compressed-air lines must be laid and fitted properly. Ensure that no
connections are interchanged. The fittings, lengths and quality of the hoses must
comply with the technical requirements!
Noise
• During operation all sound baffles must be closed!
• Wear ear protectors if necessary!
Oil, grease and other chemical substances
• When handling oil, grease and other chemical substances (battery electrolyte –
sulphuric acid, for example), observe the product-related safety regulations
(safety data sheet)!
• Be careful when handling hot consumables – burn hazard!
Battery
• When handling the battery observe the specific safety instructions and regulations
relevant to accident prevention. Batteries contain sulphuric acid – caustic!
• Especially when charging batteries, as well as during normal operation of batteries,
an oxyhydrogen mixture is formed in the battery cells – danger of explosion!
• In the case of a frozen battery or of an insufficient electrolyte level, do not try start-up
with a battery jumper cable. The battery can burst or explode!
Tyres
• Repair work on tyres and rims must be performed by technical personnel or by an
authorized service centre only!
• Damaged tyres and/or wrong tyre pressure reduce the operational safety of the
machine. Therefore perform regular checks of the tyres for
• Prescribed tyre pressure and
• Damage!
• Do not inflate tyres with inflammable gas – danger of explosion!
Check the wheel nuts once a day for tightness. After changing wheels, retighten the
wheel nuts after 10 operating hours!