1-20 BA 348-01 * 2.0 * 34801b110.fm
1 Introduction
Labels inside the cabin
Label: stopping/parking the machine
The parking brake effect is applied electrically/hydraulically, via a brake valve,
to the brake discs in the front wheel motors.
In order to prevent the machine from rolling away after parking it, do not raise
the front axle or release the load on it by lowering the attachment!
1 Empty the bucket or pallet forks
2 Park the machine on firm and level ground (avoid slopes)
3 Align the bucket or pallet forks parallel to the ground and lower the loader unit to the
ground without applying any pressure to it (1)
4 Apply the parking brake with the switch (2)
5 Switch off ignition and remove the ignition key (3)
6 Release the pressure in the lift and tilt rams.
To do this: move the control lever as far as it will go in all directions (4)
7 In addition to the parking brake, secure the machine on slopes by placing chocks
under the wheels
Location
On the pillar on the right inside the cabin
Machine stability label
Ensure machine stability.
• Read and understand the Operator’s Manual
Location
On the pillar on the right inside the cabin
Operator’s Manual label
Caution. Read and understand the Operator’s Manual before starting up, and befoe
servicing or repairing the machine
Location
On the pillar on the right inside the cabin
Fig. 21 : Machine stability label
Fig. 22 : Machine stability label
Fig. 23 : Operator’s Manual label
To Next Page
Loading...
