BA 348-01 * 2.0 * 34801b510.fm 5-25
Maintenance 5
Cleaning/replacing the fine-dust filter (from date of construction 43/2013)
The fine-dust filter is located in a drawer under the steering column.
Clean the filter as follows:
☞Remove knurled screws A
☞Pull out drawer B with the fine-dust filter
☞Remove fine-dust filter C and check it for damage
☞Knock the fine-dust filter on a plate on either side. If necessary, blow compressed air
from the inside to the outside to clean the filter, or wash it with water and allow to dry
➥Replace the fine-dust filter every 500 o/h (service hours) by a new one
➥Replace the fine-dust filter more frequently if the machine is used in severe dust conditions
☞Clean the inside of the filter housing (with compressed air, wash it if necessary)
☞Insert the fine-dust filter in the drawer
➥Ensure that the fine-dust filter is positioned properly
☞Push in the drawer and secure it with knurled screw A
Fig. 187 : Fine-dust filter from 43/2013
B
A
C
To Next Page
Loading...
