3-78 BA 348-01 * 2.0 * 34801b340.fm
3 Operation
Safety instructions regarding work with a full standard bucket
Risk of accidents. Risk of injury. If it is tilted in in transport position, the
standard bucket is moved parallel to its initial position as the loader unit is
raised!
If the standard bucket is unintentionally tilted in to the limit in this position
Fig. 102/A, material may fall over the rear of the bucket.
☞Do not tilt in a standard bucket filled with material in this position
☞Slightly readjust the standard bucket if necessary (tilt out Fig. 102/B)
☞In case of a bulky load:
• Secure the load and if necessary, fit the rear of the bucket with a protection
• Install a protective screen (option) onto the cabin
– see chapter 1 “Machine overview” on page 1-7
• Use attachments with hydraulic grabs (option)
– see chapter 1 “Certified attachments” on page 1-13
☞Ensure good visibility of the material you want to pick up and of the work
and travel range
☞Raise a full bucket only at the tilt-out position, and only when the machine is
at a standstill!
Risk of tipping over. Risk of accidents. The wheel loader can tip over when
turning or travelling on slopes with a full bucket.
☞Tilt in the standard bucket completely
☞Set the loader unit to transport position –seeTravelling with a standard
bucket during work operation on page 3-77
☞Travel in reverse when transporting a standard bucket loaded with material
on a slope
☞Do not perform any U-turns on steep slopes!
Fig. 102 : Safety instructions for transporting material
A
B
Wrong
Right
To Next Page
Loading...
