5-38 BA 348-01 * 2.0 * Aggressive Medien.fm
5 Maintenance
Applying the protective anticorrosion coating
Bear in mind the following instructions as you apply the anticorrosive wax:
Carefully cover all fastening surfaces and elements to which the anticorrosive
protection may not be applied –seeComponents coated with anticorrosive
wax on page 5-36
• ANTICORIT BW 366 can be applied with a brush, by means of immersion or with all
commercially available spray guns.
• ANTICORIT BW 366 protective coating can be removed with petrol, RENOCLEAN E/K
or FUCHS MULTICLEAN as required.
• ANTICORIT BW 366 spots are difficult to remove on clothing.
• Affix a “Wet paint!” or a similar sign to newly coated machines.
Treatment of oxidized surfaces
If in spite of all precautionary measures some components should be affected by corrosion
(oxidized), proceed as follows:
Electric connections
☞Remove the remaining protective wax in the oxidized area with petrol, RENOCLEAN E/K or
FUCHS MULTICLEAN
☞Treat the affected area with an oxide solvent, such as KONTAKT 60, and rinse it with
KONTAKT WL, for example
☞Treat the contact surfaces of the connection with KONTAKTSPRAY WD 40, for example
☞Establish the connection
☞Apply/spray anticorrosion wax onto the electric connection from all sides
Sheet-metal parts
☞Remove the remaining protective wax in the oxidized area with petrol, RENOCLEAN E/K or
FUCHS MULTICLEAN
☞Remove all remaining corrosion and paint coating from the affected area down to the
bare material, otherwise the paint coating will not adhere properly!
☞Clean the affected area with a cleaning solvent, and apply a 2-component prime coating
and then a 2-component paint coating to it
☞Then preserve the area with anticorrosion wax
To Next Page
Loading...
