BA 348-01 * 2.0 * 34801b330.fm 3-23
Operation 3
3.13 Seat belt (lap belt)
Notices on the seat belt
In order to avoid risk of accident and injury, fasten the seat belt (lap belt)
during machine travel and operation!
☞Bear in mind the following when fastening the seat belt:
• Do not twist the seat belt when you fasten it!
• Seat belt must run over the hips – not over the stomach – and must
always be applied tightly!
• Do not place the seat belt over hard, edged or fragile items
(tools, rulers, glasses, pen) carried inside your clothes!
• Never buckle up several persons!
• Check the condition of the seat belt regularly. Have damaged seat
belts immediately replaced by an authorized service centre!
• Always keep the seat belt clean, as coarse dirt can impair proper
functioning!
• There must be no foreign bodies in the buckle, otherwise the buckle
latch cannot lock into place.
After an accident the belt strap is stretched and no longer serviceable.
☞Have the seat belt replaced by an authorized service centre.
☞Have fastening points and seat fixture checked by an authorized service
centre for bearing capacity!
Fastening the seat belt
Fasten seat belt 21 as follows before starting machine travel:
☞Hold the belt at buckle latch A and run it slowly and steadily over the hips to buckle B
☞Insert buckle latch A into buckle B until it engages audibly (pull test)
☞Tighten the seat belt by pulling at its end
➥The seat belt must always be tightly in place over the hips!
Fig. 51 : Seat belt label
Fig. 52 : Fastening the seat belt
B
A
21
To Next Page
Loading...
Need help?
General
