1-18 BA 348-01 * 2.0 * 34801b110.fm
1 Introduction
Label: fuel filler opening.
Use only the diesel fuels indicated
• DIN EN 590 (EU)/ASTM D975-94 (USA)/EN 14214 (biodiesel)
• Do not use diesel fuel with additives
If other fuels are used, warranty rights shall not apply in case of diesel engine damage
(guarantee)
Location
Near the filler inlet of the fuel tank (left side of machine)
Label: No transport of persons
Warning. Lifting or transporting persons on the wheel loader, and in or on the attachments
is prohibited.
Location
On rear side of loader unit bulkhead
Load diagram for pallet forks with tyre pressure table
The framed numbers state the maximum authorized load on the fork arms for industrial
and offroad applications. The maximum load varies according to the distance between
the load centre and the rear end of the pallet forks.
Example:
➥– see chapter 3 “Load diagram for pallet forks” on page 3-104
➥– see chapter 6 “Payload with pallet forks” on page 6-12
Tyre pressure table
List of authorized types of tyres with prescribed inflation pressures
➥– see chapter 6 “Tyres” on page 6-9
Location
On rear side of loader unit bulkhead
The load diagram is valid only for applications with pallet forks. Observe the
specific load diagrams of other attachments used, for example rotary crane jib!
Fig. 16 : Label: fuel filler opening
Fig. 17 : Prohibitive label: no transport of persons
Fig. 18 : Load diagram and tyre pressure table
To Next Page
Loading...
