Kramer VS-42UHD - Page 56

VS-42UHD - Protocol 3000 51
13.3.1.13 HDCP-STAT
Functions Permission Transparency
Set: - - -
Get:
HDCP-STAT?
End User
Public
Description Syntax
Set: - -
Get:
Get HDCP signal status
#HDCP-STAT?SP
stage,stage_id
CR
Response
~nn@HDCP-STATSP
stage,stage_id,status
CR LF
Parameters
stage – 0 (input), 1 (output)
stage_id – for input stage: 1 (HDMI In 1), 2 (HDMI In 2), 3 (HDMI In 3), 4 (HDMI In 4)
for output stage: 1 (HDMI 1 Out), 2 (HDMI 2 Out)
status – signal encryption status:
0
(On),
1
(Off)
Response Triggers
A response is sent to the com port from which the Get command was received
Notes
Output stage (1) – get the HDCP signal status of the sink device connected to HDMI Out
Input stage (
0
) – get the HDCP signal status of the source device connected to the specified input
K-Config Example
Get the HDCP input signal status of the source device connected to HDMI In 1:
“#HDCP-STAT? 0,1”,0x0D