KRAUSE ClimTec - Page 36

Step 9
Take the platform which is handed up
to you. Attach the platform at the 5th
rung from the top.
Secure the platform with safety sets.
Step 10
Take the two diagonal braces which
are handed up to you. Secure the
two vertical frames by mounting the
diagonal braces crosswise between
the 3rd and 7th rung and between the
1st and 5th rung respectively, counted
from the platform.
Secure all braces with safety sets.
Take all remaining scaffold parts han-
ded up to you (4 rail braces, 2
longitudinal boards, 2 transversal
boards and 1 rail brace) and place
them temporarily on the platform.
Basicscaffoldwithrstandsecondextension
67 68
Basicscaffoldwithrstandsecondextension
Step 12
Take the longitudinal and transversal
board which are handed up to you.
First mount the short transversal
board, ensuring that the notches face
upwards. Then mount the longitudinal
boards as shown the picture to the
right.
This picture shows the completely
mounted scaffold with basic scaffold,
rstandsecondextensionelements
and 20 ballast weights.
Step 11
Climbing half standing down in the
hatch, give the rail braces and diagonal
brace up.
Secure the vertical frames by mounting
the rail brace between the 1st rung on
the one side and the 4th rung on the
other side.
Mount the rail braces at the front and
at the back at the level of the 1st and
3rd rungs. Secure all braces with safety
sets. Climb only then on the platform.