14 ELECTRICAL SYSTEM 117
100151-10
Main work
– Connect the battery charger to the battery. Switch on the battery charger.
Battery charger (58429074000)
You can also use the battery charger to test rest potential and start potential of the bat-
tery, and to test the alternator. With this device, you cannot overcharge the battery.
Info
Never remove lid
.
Charge the battery with a maximum of 10% of the capacity specified on the bat-
tery housing
.
– Switch off and disconnect the charger after charging.
Guideline
The charge current, charge voltage and charge time must not be exceeded.
Charge the battery regularly when the
motorcycle is not in use
3 months
Finishing work
–
Install the battery. x ( p. 114)
– Mount the seat. ( p. 75)
– Set the clock. ( p. 32)
To Next Page
Loading...
Need help?
General
