15 COOLING SYSTEM 136
Alternative 2
Coolant (mixed ready to use) ( p. 181)
– Mount the radiator cap.
15.4 Draining the coolant x
Warning
Danger of scalding During motorcycle operation, the coolant gets very hot and is under pressure.
– Do not remove the radiator cap, radiator hoses or other cooling system components when the engine is hot. Allow the engine
and cooling system to cool down. In case of scalding, rinse immediately with lukewarm water.
Warning
Danger of poisoning Coolant is poisonous and a health hazard.
– Coolant must not come into contact with the skin, eyes, or clothing. If contact occurs with the eyes, rinse with water immedi-
ately and contact a physician. Immediately clean contaminated areas on the skin with soap and water. If coolant is swallowed,
contact a physician immediately. Change clothing that is contaminated with coolant. Keep coolant out of reach of children.
102016-10
– Stand the motorcycle upright.
– Place a suitable container under the engine.
–
Remove screw
. Take off the radiator cap.
– Completely drain the coolant.
–
Mount screw
with a new seal ring and tighten it.
Guideline
Plug, drain hole of water pump M10x1 15 Nm
(11.1 lbf ft)
To Next Page
Loading...
Need help?
General
