KTM Freeride E-SX - Speedometer (Freeride E-XC); Overview; Activation; Message on the Speedometer

7 DISPLAY 29
402362-10
All three driving mode indicators light up and the yellow electric motor indicator lamp
(MIL)

flashes (blink code 22, 23, or 24):
– The system has exceeded the operating temperature. To protect the system from
damage, the power is reduced considerably.
Park the vehicle, if possible, and allow it to cool down. Full power is only enabled
when the component concerned has cooled down and the vehicle has been started
again.
All three driving mode indicators light up and the yellow electric motor indicator lamp
(MIL)

flashes with another rhythm:
– The system provides 50% of power as an emergency operation program.
The selected driving mode

flashes slowly and the charge level indicator lights up red or
flashes red:
– The charge state of the KTM PowerPack is below 20%. Vehicle power is reduced.
Switch off the vehicle and charge the KTM PowerPack.
7.2 Speedometer (Freeride E‑XC)
7.2.1 Overview
402361-10
1 High beam indicator lamp
2 Left button
3 Display
4 Right button
7.2.2 Activation
402361-01
Activating the speedometer
The speedometer is activated when one of the buttons is pressed or an impulse comes
from the wheel speed sensor.
7.2.3 Message on the speedometer
401901-01
Possible states
Battery voltage of the speedometer – Battery voltage of the speedometer
is too low. Change the battery.
Service – A service is due. Contact an authorized KTM workshop.
7.2.4 Setting the speedometer
Condition
The motorcycle is stationary.