KTM Freeride E-SX - 12 Service Work on the Chassis; Raising the Motorcycle with the Lift Stand; Removing the Motorcycle from the Lift Stand; Bleeding the Fork Legs

12 SERVICE WORK ON THE CHASSIS 49
12.1 Raising the motorcycle with the lift stand
Note
Danger of damage The parked vehicle may roll away or fall over.
– Always place the vehicle on a firm and even surface.
Preparatory work
– Deactivate the vehicle. ( p. 37)
– Fold the seat up. ( p. 63)
– Remove the KTM PowerPack. ( p. 94)
– Mount the covering cap. ( p. 64)
401942-01
Main work
– Use the motor guard underneath the motor to raise the vehicle.
Lift stand (54829055000)
The wheels are no longer in contact with the ground.
– Secure the motorcycle against falling over.
12.2 Removing the motorcycle from the lift stand
Note
Danger of damage The parked vehicle may roll away or fall over.
– Always place the vehicle on a firm and even surface.
401943-10
Main work
– Remove the motorcycle from the lift stand.
– Remove the lift stand.
–
To park the motorcycle, press side stand

to the ground with your foot and lean
the motorcycle on it.
Finishing work
– Install the KTM PowerPack. ( p. 94)
– Lock the seat. ( p. 63)
12.3 Bleeding the fork legs
Preparatory work
– Deactivate the vehicle. ( p. 37)
– Fold the seat up. ( p. 63)
– Remove the KTM PowerPack. ( p. 94)
– Mount the covering cap. ( p. 64)
– Raise the motorcycle with the lift stand. ( p. 49)
C00687-10
Main work
(Freeride E‑SX)
–
Release bleeder screws

.
Any excess pressure escapes from the interior of the fork.
– Tighten the bleeder screws.