FC3160-3560-4060 TCD
84
11. - Maintenance and storage
KN284EGB_A
Mower conditioner
- Remove filler plug (1) and its washer.
- Place a container of sufficient capacity under
drain plug.
- Remove drain plug (2) and its washer.
- Allow oil to drain completely.
- Wait for dripping to stop.
- Clean and reinstall drain plug (2) and its
washer. (Replace if necessary).
- Pour the recommended oil quantity and quality
through the opening of fill/dipstick plug (1).
- Check angle gearbox oil level:
• The "MAX" level corresponds to the mark on the
dipstick plug.
• The "MIN" level corresponds to the end of the
dipstick plug.
- Clean and reinstall filler plug (1) and its
washer (Replace if necessary).
Side gearbox
- Before draining oil, operate the machine for a
few minutes so that the oil warms up.
FC3160TCD FC3560TCD FC4060TCD
Type of oil Synthetic oïl for mechanical drives.
When changing the oil, it is recommended to use either an identical mineral oil or
a synthetic oil of type PAO (Poly-Alpha-Olefine) with viscosity grade SAE 75W90.
Oil volume 2.7-L (0.71 US gal) 2.7-L (0.71 US gal) 2.9-L (0.77 US gal)
Viscosity 75W90
Specification API-GL5 (extreme pressure)
To Next Page
Loading...
