KUHN GMD310 - At the Start of each Season; Dismantling and Scrapping of the Machine

GMD240 - 280 - 310
102
10. - Maintenance and storage
KN204BGB_G
Disc mower
10.4.2 At the start of each season
- Re-read the operators' manual.
- Wipe off grease on cylinder rods.
- Inspect and replace worn knives and bolts.
- Check that all nuts and bolts are sufficiently
tightened.
- Check belt condition. Replace them if necessary.
- Check belt tension. Retension if necessary.
- Lubricate moving parts and articulations.
- Lubricate moving parts and pivot pins.
- Grease the transmission.
- Make sure that all protection devices are in place
and in good condition.
10.5 Dismantling and scrapping of the machine
At the end of the machine's life, the various machine components must be disposed of or recycled in
compliance with local regulations in force.
- Make sure the machine is stable (parking stands, holders, slings, etc.) prior to carrying out any repair or
maintenance.
- Before any repair or maintenance on a circuit including an accumulator, depressurize the circuit. Do not
grind or drill on the shell of the hydro-pneumatic accumulator. Always empty and recover the oil of the
machine's gearboxes and the hydraulic circuit to entrust it to waste oil recycling companies.
- Empty fluids or components such as coolant, cooling liquid, brake fluid, batteries, filters and entrust them
to a specialized company.
- Cut the electric power prior to carrying out any repair or maintenance on the circuits or electric/electronic
components. Entrust electronic waste such as control box, wiring harness... of the machine to a
specialized company.
- Separate the metal components, plastic components and rubber components and entrust them to
specialized companies.