KUHN GMD310 - Precautions for Machine Use; Likely Critical Failures

4. - Safety
GMD240 - 280 - 310
25
KN204BGB_G
Disc mower
4.3.10 Precautions for machine use
After each use, check the cutting tools (discs,
knives) and their attachment hardware in
accordance with the instructions given in the
present manual. Immediately replace any worn,
damaged or missing cutting tool or element. To do
this, use the tool outfit supplied with the machine.
For your safety, only use genuine parts !
Regularly check the condition of the protection
covers. Immediatly replace any worn, damaged or
missing cover. Before engaging the PTO, rest the
cutterbar on the ground. Make sure all the guards
are in place. Keep all persons and animals away
from the danger zone.
Stay a safe distance from the machine when the
cutting tools are in movement.
Never work in reverse.
After disengaging the PTO drive, cuttings tools can
continue rotating for some time. Stay away from the
machine until all moving parts have come to a
complete standstill.
- If the machine hits an obstacle, disengage the
PTO drive, stop the tractor engine, remove the
ignition key and wait for all moving parts to come to
a complete standstill. Check the entire machine for
any damage before resuming work.
4.3.11 Likely critical failures
• 133993: Specific requirements for countries member of the Eurasian Economic Community (EAC
marking).
• 133994: Specific requirements for countries member of the Eurasian Economic Community (EAC
marking).
• 133995: Specific requirements for countries member of the Eurasian Economic Community (EAC
marking).