KUHN GMD310 - Wear Skids

116 pages

Save Page as PDF

To Next Page

To Previous Page

9. - Optional equipment

GMD240 - 280 - 310

KN204BGB_G

Disc mower

9.17 Wear skids

GMD240-280-310:

Wear skids can be welded underneath the disk

guard to improve its resistance to wear in difficult

working conditions.

Main Page

Dear Owner3
Table of Contents4
Contents4
Identification of the Machine8
Front View8
Rear View8
Model Identification Plate9
Optional Equipment10
Safety11
Description of Symbols Used in this Document11
Safety Instructions12
Introduction12
Read and Follow the Safety Instructions12
Precautions to be Taken before Carrying out any Operations on the Machine13
Precautions to Take before Using the Machine13
Precautions When Driving14
Precautions When Driving on Public Roads14
Maximum Speed18
Precautions During Manoeuvres18
Hydraulic Circuit19
Limit State Criteria19
PTO Shaft20
Remote Controlled Components21
Safety Decals21
Waste Disposal22
Precautions When Coupling22
Precautions to Take before Using the Parking Stands22
Incorrect Use of the Machine by the User23
Projection of Stones and Foreign Objects23
Precautions for Maintenance and Repair Work24
Precautions for Machine Use25
Likely Critical Failures25
Location and Description of Safety Decals on the Machine26
Location of Safety Decals26
Road Safety Equipment and Recommendations31
Machine Specifications33
Description and Glossary33
Technical Specifications34
Required Equipment36
Primary PTO Shaft36
Mechanical Safety Release36
Cutter Bar37
Sound Levels38
Putting into Service39
Description of Control Elements39
Coupling and Uncoupling40
Description of Coupling Elements40
Preparing the Tractor40
Preparing the Machine42
Coupling the Machine44
Hydraulic Connections45
Electrical Connection46
Primary PTO Shaft46
Adjusting the Machine48
Uncoupling the Machine48
Instructions for Transport51
Putting the Machine into Transport Position51
Instructions for Work54
Putting the Machine into Work Position54
Putting the Machine in Headland Turn Position56
Adjustment57
Adjustments in Working Position57
Cutting Height58
Swathing System58
Compensating Spring Tension59
Machine Use60
Headland Turn Maneuvers61
Drive Speed61
Machine Safety62
Optional Equipment65
3/8'' - 6 Spline Pto Shaft65
32 X 38 - 8 Spline Pto Shaft65
High Cone Disc Kit65
Inner Swath Disc66
Inner Swath Shield66
Raised Skid Shoes67
Side Deflector67
Side Deflector with High Cone Disk68
Frame Connection Arm/Cutterbar68
Longer Hitch Pins68
Chain Stroke Limiter69
Adjusting the Machine70
Lighting and Signalling71
Electrical Connection71
Lateral Signalling Equipment (for France)71
Lighting and Signalling (Only for USA)72
Quick Hitch Connector72
Drive Kit 1000 Rpm72
Wear Skids73
Maintenance and Storage74
Frequency Chart74
Lubrication75
PTO Shaft76
Grease77
Draining79
Maintenance82
Belt Tension83
Checking Cutterbar Oil Level83
Check Angle Gearbox Oil Level85
Breather Plug Checking and Cleaning85
Inspection of Knives and Securing Elements86
Spring Plate Replacement100
Outer and Inner Cones101
Storage101
At the End of each Season101
At the Start of each Season102
Dismantling and Scrapping of the Machine102
Storage103
Troubleshooting Guide104
Appendix106
Calculating the Load on an Axle106
Limited Warranty113

KUHN GMD310 - Wear Skids

Table of Contents

Related product manuals