KUHN GMD310 - Page 17

4. - Safety
GMD240 - 280 - 310
17
KN204BGB_G
Disc mower
• Stage 2:
- Couple the machine to the tractor.
To measure:
- Load on front axle (t1):
• Tractor + machine (transport position).
To do:
- If the front axle load (t1) is below 20% of the tractor
tare (T), add ballast weights (M1) to exceed the
minimum load on the front axle.
Example:
• (T) = 7500 kg (16535 lb)
• 20% of T = 1500 kg (3300 lb)
• (t1) = 700 kg (1545 lb).
• 700 kg (1545 lb) < 1500 kg (3300 lb).
- Add ballast weights until the minimum front axle
load is exceeded.
- Repeat checking procedure.
• Stage 3:
To measure:
- Total weight (t):
• Tractor + machine (transport position).
• Ballast weights.
Checking:
- To go to the next stage:
• Check in the tractor's operator's manual that the
value measured is below the tractor's Gross
Combined Weight Rating.
To do:
- If t < PTAC go to the next stage.
- If the total unit weight exceeds the tractor Gross
Combined Weight Rating in accordance with the
countrie's legislation, empty the hopper to travel on
public roads.
Example:
• (t) = 10000 kg (22046 lb).
• PTAC = 13000 kg (28660 lb).
• t < PTAC : Go to the next stage.
t1 = _____kg
t1 = ________ kg
t1 < 20% Tt1 < 20% T
t1 t1 ≥ 20% T 20% T
kgkg
t = _____kg
t = ________ kg