GMD240 - 280 - 310
50
6. - Putting into service
KN204BGB_G
Disc mower
- Uncouple the PTO shaft.
- Place PTO shaft in holder (1).
- Disconnect and store hydraulic hose in holder (2).
- Remove cord from tractor and store it in its holder
on the machine.
- Detach the top link from the machine end.
- Release the lower links.
- Lower the tractor three-point linkage.
When the following equipment is fitted:
Mechanical safety release + Hydraulic pivot +
Lighting and signalling
- Disconnect and store hydraulic hoses in holder
(2).
- Disconnect and store lighting equipment 7-pin
plug in its holder (2).
The machine is uncoupled.
- Always park the machine with the cutter bar
in horizontal position.
To Next Page
Loading...
