GMD240 - 280 - 310
84
10. - Maintenance and storage
KN204BGB_G
Disc mower
- Place cutter bar in vertical position.
- Wait one hour for the oil to accumulate in
the lower part of the cutter bar.
- Remove filler plug (1) and its washer.
- Check the oil level: The oil must reach the lower
edge of the filling hole (1).
- Top up if necessary.
- Clean and reinstall filler plug (1) and its
washer. Replace if necessary.
If it is found that the transmission case is very hot
to touch by hand, there is no cause of alarm
provided:
• Lubrication recommendations have been
respected.
• Discs can be rotated freely by hand when the
machine is hot.
1
To Next Page
Loading...
