Chapter 4
Programming SP2
<Figure4‐10StoringEffectSetting>
• Changing Reverbs
<Figure4‐11Reverbbutton>
→Forthisexample,we’regoingtochangetheReverbappliedtoProgram49,AcousticGuitar.
1. SelectProgram49(n49)AcousticGuitar
2. Press[Reverb]button.Thedisplaywillshow“b08”andtheLEDin[Edit]buttonintheEdit
regionofthe SP2’sfrontpanelwillblink.Thismeansthatthe SP2isnowinReverbEditor
mode.Thecapital“b”meansthattheSP2isnowinReverbEditormodeandthefollowing
two digits indicate the type and the variation number of the reverb associated with the
currentlyselectedprogram.
<Figure4‐12ThedisplayinReverbEditormode>
3. Select the desired type of reverb with the upper part of Sound Select buttons in the
Categoryregion.ThebuttonsarelabeledRoom1,Room2,Chamber,Hall1,Hall2,andHall3.
After making selection, select the desired preset with one of the the lower 8 buttons. For
moreinformationaboutthereverbs,refertoAppendixB‐7,EffectsandReverbs.
4. Press [Store] in the Edit region. The SP2 will ask if you want to store the changed effect
setting of the current Program.Store the change with [+/Yes] button and the procedure is
completed.Now,theSP2willreturntoProgrammode.
４-6
To Next Page
Loading...
